Performance characteristics

In contrast to DowFLMTECTMBW30-440iUnder the conditions of the same water production and the same operating flux, the operating pressure of the component decreases40%.

Under the condition that the effluent water quality is comparable, comparedFLMTEC LE-440The water production capacity is high10%It can achieve a low total cost for industrial pure water preparation.

iLECTMThe end face self-locking connection technology not only reduces the system operation cost but also lowers the riskOThe risk of a decline in the quality of the produced water caused by the leakage of the sealing ring.

The compatible design adopts the current inner diameter of1.125The industrial standard production water pipe in inches can thus be connected in conjunction with the existing brackish water film elements that are inserted and connected.

Product real photos

Product specification

1,The water production capacity and desalination rate are based on the following test conditions:2000ppmNaCl,150psi(10.3bar"25℃,pH=8.

2,The flow rate of specific components may vary, but it will not be lower than the given value15%.

3,Ensure that the deviation of the processing area is within+/-3%Within.

LE-440iThe component can be placed with an inner diameter of203Inside a pressure vessel in millimeters.

Each one adoptsiLECThe length of the membrane element at the end of the end face self-locking connection1029mmThe net length after connection is1016mm

Work limit

aWhenpHThe value exceeds10At that time, the highest temperature for continuous operation is35℃

bIn some cases, the presence of free chlorine and other oxidants can lead to the failure of water production membrane elements. It is recommended to remove the residual free chlorine through pre-treatment before the membrane elements come into contact with these oxidants.