Technical parameters;

●Controller mode----------------------------------------------Flow type/Downstream regeneration

●Applicable water pressure----------------------------------------------0.15-0.6MPa

●Power adapter----------------------------------------------100-240V/50-60Hz

●Applicable water temperature------------------------------------------------5--45℃

●Large water production capacity----------------------------------------------2 m3/h

●Adapt to the diameter of the softening tank(in)------------------------------------6-12″

●Inlet and outlet------------------------------------------------3/4″F(Internal teeth

●Drain outlet--------------------------------------------------1/2″M(External teeth

●Salt suction port--------------------------------------------------3/8″M(External teeth

●tube--------------------------------------------------1.05 ″OD (26.7mm)

●Base(Connection port with the can)----------------------------------------2-1/2″8NPSM

Functional features;

■The end face sealing sheet does not leak when opening and closing,The mechanical performance is reliable.

■It has a key lock function: the keyboard will automatically lock after one minute,The next operation requires re-unlocking,To prevent any misoperation.

■LEDDynamic color bar display: A flashing color bar indicates that it is in operation,Otherwise, it indicates that it is in a regenerative state.

■Long-term power outage warning: Power outage for more than three days,The clock flashing for a long time indicates that the current time needs to be reset,The regeneration time has been set to remain unchanged.

■When regenerating the single-tank control valve, no water comes out of the outlet.

■With signal output port: normally open in the electronic control motherboard,Always closed,The common three port leads are externally connected to solenoid valves or booster pumps.

■A valve has a flow delay typeA-01Or traffic immediate-typeA-02Two traffic modes,It can be changed through the setting of parameters within the program.

■The number of days with a large interval for regeneration can be set: It indicates that no matter how much flow is set or operated,Exceeding the maximum regeneration days0-40Regeneration will be initiated before the flow rate reaches the set value.