Fully automatic water softener

Industrial boilers are one of the commonly used equipment in the field of industrial production. However, if the water used in the boiler contains hardness salts, such as calcium and magnesium ions, scale will form on the heating surface of the boiler, thereby reducing the thermal efficiency of the boiler, increasing fuel consumption, and even causing local overheating, damaging components and leading to explosions. Therefore, industrial boilers need to undergo water softening or desalination treatment. In industry, hardness is generally considered<1The water is called soft water.1-10They are generally referred to as hard water or hardness>10Water with high hardness is often referred to as such. Among the industrial boilers in operation in our country, the failure rate of boilers caused by water quality issues is as high as25%. This is because traditional water softening treatment equipment is complex to operate, has poor working reliability, and a high failure rate. The equipment is in an abnormal working state for a long time, and the water quality cannot be guaranteed, thus resulting in a high failure rate and short service life of the boiler.

1Water consumption per hour (unit:)T/H)
2Raw water hardness (single:mmol/L(Subject to the water quality inspection report)
3Potassium and sodium content of raw water (unit:)ppm";" (Subject to the water quality inspection report)
4Effluent hardness requirements (unit:)mmol/L";"
5Work pressure (Unit:)Mpa";" (0.2Mpa-0.6Mpa"Jia Wei"0.25Mpa";"
6Continuous water supply time (unit:)H)
7Ambient temperature and raw water temperature (unit:)℃)

1There is no need to specially build an installation foundation; a level ground is sufficient.
2If the inlet water pressure is lower than0.2MpaA pipeline pump must be installed.
3Before use, the pipeline must be flushed first to prevent impurities from blocking the valve body and contaminating the resin.
4Iodized salt or calcium salt should not be used as regenerants. Salt should be added to the salt tank regularly to ensure the saturation concentration of the brine (the dissolution time should be no less than six hours).