The filter element adopts imported polyethersulfone microporous filter membrane and imported non-woven fabric or wire mesh support layer folding. The outer cylinder, core column and end cover of the filter element are all made of polypropylene material. The sealing of each part is formed by hot melt welding technology, without any adhesive, no pollution and no medium shedding.

Product features

The filter membrane has good hydrophilicity, uniform pore size distribution and large flux

It has wide chemical compatibility and good acid and alkali resistance as well as heat resistance, and is particularly suitable for the filtration of high-temperature liquids

The filter element conforms toFDABiological standard

All products go through100%The completion test was conducted and it was rinsed with high-purity water

Application fields

Terminal filtration for pharmaceuticals and biological products

Terminal filtration for drinking water, beverages, ultrapure water, alcoholic beverages, etc

Main technical parameters

Filtration accuracy0.1μm, 0.22μm,0.45μm, 0.65μm,0.8μm,1.0μm

Filter element length10",20", 30", 40"

Filtration area/10"Length0.65m2"10"],1.30m2"20"],1.95m2"30"],2.60m2"40":

Each filter element has undergone an integrity test

High operating temperature85ºC(Pressure difference0.2MPawhen)

High work pressure1.6MPa@25ºC

Positive withstand pressure difference0.4MPa@25ºC

Reverse withstand pressure difference0.3MPa@25ºC

Steam121±2ºC, Every time30min

Interface type222Insertable type226Card-in type

OThe materials of the sealing ring are fluororubber and silicone rubber

Overview and Features

Polypropylene pleated filter cartridges are a type of deep filtration filter cartridge, typically used for pre-heating, clarification filtration and terminal filtration of liquids. It has the following features: using ultrafine polypropylene fiber membrane as the filtration medium, low pressure difference, high flux, good filtration accuracy, low economic cost, all-polypropylene structure, and the end cover, shell and rod are all made of polypropylene material. It is fused by hot-melt process, that isPPwithPPIt melts and bonds by itself without any adhesive. It has wide chemical compatibility; It features a series of apertures and multiple interface forms.

Contents 1PolypropylenePPFolded filter element----Universal fine filter element

2PolyethersulfonePESFolded filter element----Type fine filter element

3PolytetrafluoroethylenePTFEFolded filter element----High-temperature gas-type fine filter element

4Nylon filmN66Folded filter element----Type fine filter element

5Polyvinylidene fluoride filmPVDFFolded filter element----Type fine filter element.

Parameter

Specification: Conventional10~40Inches, special items can be customized. Outer diameter approximately60MMThe inner diameter depends on the interface method

Interface226;222;224;220;215; Flat press type Finned type Three-piece type; Meltblown plug.

Precision0.05μm~70μm

Test: Each filter element is tested according to the countryGMPThe conditions require that the process be completed23℃Pure water integrity test

Pressure difference: Positive4.2bar;Reverse2.1 bar

Filtration area≥0.55㎡ every10Inch calculation

Working temperature and pressure difference

Atype<60℃Pressure difference2bar----Polypropylene material

Btype<80℃Pressure difference2bar----High-temperature resistant material

Ctype<95℃Pressure difference1bar----Imported polypropylene and stainless steel materials

Dtype<125℃Pressure difference1bar---- PVDFMaterial

Traffic0.5 M³every10Inch calculation